Forman3D,  Custom 3D Printing, Laser Cutting, Laser Engraving and Vinyl Graphics
  • Home
  • Design Services
  • 3D Printing
  • Laser
  • Store

The laser is up and running!

9/17/2014

0 Comments

 

It's been a long night but the laser is installed and running. We just did some power tests and it's cutting our first stencil for some snow removal signs in cardboard.

Picture
Picture
You can see at the top of the sheet where we started at 1/2 power and the engrave ( raster) mode was cutting clear through the cardboard. This laser has some juice! We adjusted it to 5% power for the rest of the layout so it just marks it on the cardboard. After we proof the marks we will go back and set up a vector cut tomorrow.
0 Comments



Leave a Reply.

    Author

    ... just a squirrel, trying to chase a nut! 

    Tweets by @Forman3d

    Categories

    All

    RSS Feed

    Archives

    July 2015
    March 2015
    February 2015
    January 2015
    December 2014
    November 2014
    October 2014
    September 2014

About Us
Copyright Forman3D, Amherst NH 2015

Contact Us
  • Home
  • Design Services
  • 3D Printing
  • Laser
  • Store